FLIR Moisture Meters

FLIR Moisture Meters product photo

FLIR's moisture meters add a thermal camera to the standard pin/pinless sensor: wet material runs cooler as it dries, so the thermal image shows a damp patch before you probe it. The base model reads up to 19mm deep pinless, or 0-100% wood moisture equivalent with the pin probe.

The thermal image shows where to check; the pin or pinless sensor then confirms the actual moisture reading at that spot.

Specifications

Base model built-in thermal camera80 x 60 (4,800 pixels), FLIR Lepton sensor
Base model pinless depthUp to 19mm (0.75in), in 100ms
Base model pin probe range0-100% wood moisture equivalent, ±5%, across 9 material settings, in 750ms
Base model battery / durability18 hours continuous use, drop-tested to 3 meters
Base model storageUp to 9,999 saved images
Mid-tier model thermal camera160 x 120, with MSX
MR277 thermal resolutionRoughly 4x FLIR's earlier IGM-series moisture meters
Mid-tier and MR277 warranty10-year limited warranty

How a Thermal Moisture Meter Actually Works

The thermal camera and the pin/pinless sensor measure two different things that work together: the thermal image shows surface temperature, and a damp area typically runs cooler than the dry material around it as it evaporates, so the camera points to where a problem likely is. The pin or pinless sensor then takes the actual moisture reading at that spot - the thermal image alone does not tell you a moisture percentage.

Pin vs Pinless: Why the Base Model Has Both

The pinless sensor on the base model reads up to 19mm (0.75in) deep in about 100ms without leaving a mark, which makes it the faster way to scan a wall or surface. The pin probe takes about 750ms and gives a calibrated 0-100% wood moisture equivalent reading across 9 material settings, at the cost of two small holes - useful for confirming a borderline pinless reading rather than as the first pass.

Popular options on Amazon

Prices change often - check the current price on Amazon.

Resolution Differences Between the Three Models

The base model's built-in camera is 80x60 (4,800 pixels); the mid-tier model steps up to 160x120 with FLIR's MSX image enhancement; the FLIR MR277 is rated at roughly 4x the resolution of FLIR's earlier IGM-series meters. Higher resolution mainly helps spot a smaller damp patch at a greater distance across a wall - it does not change the moisture percentage reading itself, which still comes from the pin or pinless sensor. See the full FLIR camera comparison for how these fit against FLIR's dedicated inspection cameras.

Frequently Asked Questions

How deep does a FLIR pinless moisture meter read?

Up to 19mm (0.75in) on the base model, in about 100ms.

What is the difference between pin and pinless moisture readings?

Pinless scans through to a set depth without marking the surface; the pin probe gives a calibrated 0-100% wood moisture equivalent reading across 9 material settings, at the cost of two small holes.

Does a FLIR moisture meter need a separate thermal camera?

No - FLIR's moisture meters build a thermal camera (a Lepton sensor on the base model) directly into the meter.